Ballast MH/HPS/CMH 250-600W + Super Par 10% - Dimmable - Superplant

Ballast for HPS or MH or CMH from 250W to 660W by Superplant

Superplant offers you its highly efficient and energy saving All in One digital ballast.
It has a high power factor, high luminous efficiency and low THD.

For MH or HPS or CMH bulbs

The All in One digital ballast is designed to light HPS, MH or CMHlamps.
Make sure that the lamp wattage and lamp voltage match the specifications of the All in One Superplant ballast.
Its high operating frequency (60KHZ-130KHZ.) provides a constant power output to the lamp, which helps to extend the life of the lamps and increases the efficiency of the light.

Growing area: 150 x 150 cm
Flowering area: 120 x 120 cm

DIMMABLE DESIGN

This design can run a lamp at rated power and consists of a four-phase controller to set the ballast output to 250W, 315W, 400W, 600W or 660W. The latter power corresponds to the Super Par function, which will increase the brightness by 10%.
Be sure to run your lamp continuously at 100% for 10 minutes before switching to other settings. Switching settings quickly can damage the lamp.

PROTECTION MECHANISM

This ballast is equipped with short circuit protection, open circuit protection, ignition failure protection and end of lamp life protection technology.

Technical Specifications

Lamp: 250-400W-600W lamps (MH/HPS) - 315W lamps CMH
Input power: 680W
Input voltage range: 176-264V
Input voltage: 220-240V
Input current: 3A
Input frequency: 50/60Hz
Max output power: 660W
Output frequency: 60KHZ
Dimmer operation: 250W - 315W - 400W - 660W
Leakage current: 2.35mA
Total harmonic distortion : <8%
CF Lamp / peak factor : <1.6
Power factor : > 0.98
Open circuit voltage: 250Vrms
Operating frequency: 60KHZ-130KHZ
Ignition voltage: 3.5KV-4KV
Ignition time: 30MS
Inrush current: 6.5A
Current protection: 5A
Insulation resistance: 5MΩ
Insulation voltage: 3.5KV
Lamp failure detection: YES
Lamp power: Constant
Lamp flicker - acoustic resonance: NO
RF interference: NO
Max case temperature: 80°C
Ambient temperature: -25 to 40°C
Operating humidity: 20% - 95%
IP environment requirement: IP23
Unit weight: 2.2 Kg
Unit dimensions: 198 x 200 x 100mm